![]() ![]() Read Also: Home Depot Garage Overhead Storage Change The Garage Door Keypad Pin Press the button to operate the garage door.Next, push the up/down keys about four times until the LED light turn purple and switches off.Enter the default pin 3-5-7 on the keypad.Ensure the keypad backlighting is off and remove the protective tab from the battery holder.Put the garage opener in programming mode by setting the button on the opener unit marked as Program or Set.If you have not changed the default keypad pin yet, use the default pin. The following steps outline the keypad setup for a single garage door opener. ![]() Programming A Single Genie Garage Door Opener To A Keypad If you test the code before turning off the keypad back lit light. You have to go through the whole process again. Now getting back to the genie keypad for reset the old code by reprogramming.ġ- Hold Program button with Digit 6 and up/down button at a same time.Ģ- And then Press 3, 5, 7 and then press Program button.ģ- Next step is to reset pin by pressing whatever you want the code For example press 2344 and then press Program button and wait for the red lights to blink couple of times and then it will goes off.Ĥ- Next step is to go back to your garage door opener hit the Learn Button and you will see red light blinking below learn button.Īfter Hit the learn button you have a 30 second for verifying the code.ĥ- Go back to Keypad and press the new CODE 2344 and press up/down button.Ħ- Then go back to Garage door opener and you will see the red light blinking turn a solid red color.ħ- After you confirm about the solid red color you again have a 30 seconds timeframe, so go back to Keypad and press UP/Down Button.Ĩ- Note: Before testing your new reprogram code, you have to wait until the two backlit keypad lights turn off.Take out the light cover of the device installed inside the garage door by unscrewing it using ladder.So Here Are Steps To Follow Of How To Reprogram Genie Garage Door Keypad Note that after you open or close the door with the keypad, you can cause the door to stop and reverse by pressing any button while the doors still in motion. When you put in the code and press the up/down button, the garage door will open. Press the up/down button for a third time.Enter your pin, then press the up/down button.The long LED light will begin to flash purple. The round LED light will turn blue and then turn off. Enter a pin that is three to eight numbers in length.Enter, in order, 3-5-7, then press the PRGM/SET button.Press and hold the PRGM/SET button until the small, round LED light starts flashing red.Enter, in order, the numbers 3-5-7, then press the large up/down button.Connect the keypad to the Genie opener:.To program your Genie keypad, follow these three steps: Refer to the keypad owners manual for instructions. If youre linking the keypad to more than one garage door, the process will be different. These instructions are for linking a Genie keypad with a Genie opener for a single garage door. Genie Intellicode Wireless Keypad Programming & Installations Instructions ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |